Gefen ex-tend-it 4x4 DVI Matrix Manuale Utente

www.gefen.comwww.gefen.comwww.gefen.comen.com®www.g4x4 DVI MatrixEXT-DVI-444NUSER MANUAL

7DIP SWITCH GUIDELINESRemove TapeFrontBottomIR Switches1765443322Dip Switch# Name Description1 IR Code Dip Switch Corresponds to Dip Switch 1 on RMT-1

RS-232 INTERFACE8Binary TableASCII Corresponding RMT16-IRButtonBinary ASCII CorrespondingRMT16-IRButtonBinary1 1 0011 0001 9 9 0011 10012 2 0011 0010

4x4 DVI MATRIX RACK MOUNT DIAGRAM9

Video Amplifi er Bandwidth ...165 MHz Input Video Signal ...

DDCShort form for Display Data Channel. It is a VESA standard for communication between a monitor and a video adapter. Using DDC, a monitor can inform

TROUBLESHOOTING128 Dip Switch Bank (Pre-emphasis)Dip Switch # Name Description1 IR Code Dip Switch Corresponds to Dip Switch 1 on RMT16-IR2 IR Code Di

TROUBLESHOOTING - DIAGRAM13FrontRemove TapeBottomAuto EqualizationSwitchesPre-EmphasisSwitchesEqualization Trim Pot Display 1Equalization Trim Pot Dis

14WARRANTYGefen warrants the equipment it manufactures to be free from defects in material and workmanship.If equipment fails because of such defects

*ma-DVI-444n*Rev X120600 Nordhoff St., Chatsworth CA 913111-800-545-6900 818-772-9100 fax: 818-772-9120www.gefen.com [email protected]

Technical Support:Telephone (818) 772-9100 (800) 545-6900Fax (818) 772-9120Technical Support Hours:8:00 AM to 5:00 PM Monday thru Friday PST (Pa

TABLE OF CONTENTSIntroduction / Operation NotesFeaturesPanel LayoutUsing the 4x4 DVI MatrixRMT16-IR InstallationIR CodesDip Switch GuidelinesRS-232 In

INTRODUCTIONThank you for purchasing the 4x4 DVI Matrix.The 4x4 DVI Matrix switches four DVI sources to any four DVI displays. The 4x4 DVI Matrix swit

2FEATURESFeatures• Allows any DVI display to view any source at any time• Allows any source to be displayed on multiple displays at the same time• Mai

PANEL LAYOUT3Display 1 LED IndicatorFront PanelRS232 Controller PortDisplay 2 LED IndicatorDisplay 3 LED IndicatorDisplay 4 LED IndicatorIR SensorIR E

1 Connect all the sources to the DVI inputs on the 4x4 DVI Matrix, using the supplied cables. 2 Connect the HDMI/DVI displays to the outputs

5RMT16-IR Installation1. Remove battery cover from the back of the RMT16-IR remote.2. Verify that dip switches 1 & 2 are in the down (OFF) positio

6IR CODESIn the event of IR confl icts, please do the following:1. Remove the battery cover from the back of the RMT16-IR remote.2. Locate the Dip Swit